Heating for Mirrors to Stop Condensation
No more misty mirrors - Enerfoil low voltage and mains voltage mirror panels are available in a variety of sizes and all have a peel-off self adhesive backing for a simple installation.
The low voltage panels can be run in conjunction with the low voltage floor system using the same transformer. The double insulated mains voltage panels are connected via the lighting system and heat in 4 or 5 minutes.
ENERfoil mirror de-misting panels are the totally safe and simple answer to steamed-up mirrors. They are double insulated and designed for use in wet areas such as bathrooms, shower rooms, etc. The panel is only 0.4mm thick. It is simply installed by peeling off the self-adhesive backing and sticking it directly onto the back of the mirror.
The capacity of each panel is sufficient to warm up the mirror to 30 °C in 3 to 5 minutes. The surface temperature of the mirror is limited to 45°C. To save energy, the panel wires can be connected to the lighting system and switched on only when required. The mirror (de-misting) panel is for de-misting the mirror and is not a bathroom heater.
Enerfoil mirror de-misting panels are made from a polyester aluminium laminate heating foil set at 230 volts which is double insulated using four polyester sheets, the wires are also double insulated, waterproof and vulcanised – a totally safe system to use in your bathroom.
We also offer low voltage (24 volts) panels which work in conjunction with ENERfoil Low Voltage underfloor heating system.
| 
